How to program you motorized Roller Shades

1. Pairing with the remote

Select the desired channel you wish to program by scrolling using the left/right arrows on the remote control.

Press the P1 button on the roller shade motor for 2 seconds until the motor responds (jogs up and down once)

Within 4 seconds hold the stop button on the remote for 3 seconds (the motor will then jog up and down twice to let you know this has worked).

2. Check direction

Press the up or down button on the remote control for 2 seconds and check which direction the shade moves.

If the shade direction needs to be changed, press and hold the up and down arrow together for 2 seconds until the motor jogs up and down.

3. Set top limit

Move the shade to the desired top limit position by pressing the up arrow repeatedly. Once you’re happy with the position, press and hold up and stop together for 2 seconds to save the limit. The shade should then jog up and down twice.

4. Set bottom limit

Move the shade to the desired bottom limit by pressing the down arrow repeatedly. Then press and hold down and stop together for 2 seconds to save the limit. The shade will then jog up and down twice to confirm the selection has been saved.

Factory reset

If you make a mistake and need to start again at any point, you will need to do a factory reset. Simply push and hold the P1 button on the motor for 14 seconds. Once the factory reset is complete, the shade should then jog up and down 4 times to confirm the action.